|
The US 75 mm gun tank gun M2 and the later M3 were the standard American tank guns of the Second World War, used primarily on the two main American medium tanks of the war, the M3 Lee (M2 or M3 gun) and the M4 Sherman (M3 gun) The lightweight M6 and M5 variants were developed to equip the M24 Chaffee and the B-25 Mitchell bomber respectively. The M3 was also used on the prototype M7 Medium Tank platform. ==History== The 75 mm tank gun has its origins in the famous French Canon de 75 modèle 1897 field gun of World War I fame which was also adopted by the United States and used well into World War II as the 75 mm M1897 field gun. Both the tank and field guns fired the same range of 75x350R ammunition. The primary round was the M48 High Explosive. This 6.76 kg (14.9 lb) round travelled at 625 m/s (2,050 ft/s) and contained 1.5 pounds of TNT filling and choice of Super Quick (SQ) or Delay (PD) with 0.05 or 0.15 seconds of delay fuse. SQ was the standard setting with PD used against structures, gun positions or lightly protected vehicles. The field gun origins of the ordnance and ammunition ensured that the M2/3/6 series HE round was highly effective for its caliber. The M48 was available in 2 versions, standard or supercharge which increased the propellent charge for greater muzzle velocity ( vs. ) and range (2,300 yards greater). Other important rounds fired by the 75 mm tank guns were the T30 canister shot for use against troops in the open at short range. This was essentially a giant shotgun shell full of large numbers of steel balls. Canister was used primarily in the Pacific. There was also the M88 base-ejecting smoke round and the M89 white phosphorus (WP or "Willy Pete") round which proved highly effective in the ''bocage'' fighting around Normandy. Finally there was the armor piercing for which two different rounds were provided. The first armor-piercing round was the M72 AP-T, a plain uncapped AP round whose performance dropped off as range increased due to poor aerodynamics. M72 was replaced by the 6.63 kg (14.62 lb) M61 and later the improved M61A1 APC Shell. This was actually an HE/APC-T type or rather an Armor Piercing Capped with Tracer filled with a small quantity of High Explosive. The aerodynamic ballistic cap acted as a windscreen and improved ballistic performance, maintained velocity, and retained penetration at longer ranges. The armor piercing cap, made of a softer metal, helped to prevent shell shatter at higher velocities and against sloped and "face-hardened" armor(FHA). Once the projectile had penetrated the target a small explosive charge at the base of the shell would detonate shattering the shell, and increasing damage inside the enemy vehicle. The tracer helped in aiming of a second shot. In practice the majority of M61 rounds were shipped without the explosive filler. M61 had a muzzle velocity of 617 m/s (2024.28 ft/s) and was credited with the ability to penetrate of Rolled Homogeneous Armor plate (0° from vertical) at 500 yards range, which was a quite acceptable performance by the standards of 1942. This ammunition type proved lethal to the Panzer III and IV (up to Ausf. F2) as these tanks were protected by a maximum of 50mm of FHA with little slope, which the 75 mm M3 was capable of penetrating from 1500 m. With the later Ausf. G iteration, the Panzer IV was rearmed with KwK 40 and its frontal hull armour increased up to 80 mm, but its turret and gun mantlet retained their 50 mm thickness. This was compensated somewhat by the M4 Sherman's improved armor over the earlier M3 Lee making up for the 75 mm M3's diminishing battlefield dominance; Wa Pruef 1 estimated that the M4's glacis was impenetrable to the KwK 40 when standing at a 30-degree side angle, while the 75 mm M3 could penetrate the Ausf G's hull from 100 m in the same situation. By July 1944 complaints started to pour in about the inadequate anti-tank performance of the M4 Medium tanks fitted with the 75 mm M3 gun. During the breakout from Normandy American and British forces encountered the new generation of heavy German tanks and armored vehicles such as the Panther tank, Tiger I tank and Jagdpanzer IV tank destroyer in quantity for the first time. These vehicles had thick frontal armor that proved largely immune to the M61 projectiles fired by the M3 tank gun and severely tarnished the reputation of the M4 Medium tank. The western allies countered by equipping increasing numbers of M4 Medium tanks with the 76 mm gun M1 for the Americans and the Ordnance QF 17 pounder for the British. These guns offered much improved performance against tanks but because their High Explosive rounds were inferior the 75 mm guns', the 76 mms never completely replaced the older models. British tanks in the early years of World War II relied on high-velocity anti-tank guns such as the Ordnance QF 2 pounder and Ordnance QF 6 pounder for their primary armament. As tank guns these had the great disadvantage of either not having a truly effective High Explosive round or not even having a HE round at all. The British after experiencing the effectiveness of the American 75 mm tank guns in the infantry support role opted to adopt the American caliber and ammunition by the expedient of boring-out the 6 pounder tank gun to make the Ordnance QF 75 mm. By 1944 this had become the standard British tank gun equipping the Cromwell tank and Churchill tank for the campaigns in northwest Europe. 抄文引用元・出典: フリー百科事典『 ウィキペディア（Wikipedia）』 ■ウィキペディアで「75 mm Gun M2/M3/M6」の詳細全文を読む スポンサード リンク
|